Search results for "beam [positron]"

2020

Recent experiments have demonstrated the formation of free-standing Au monolayers by exposing the Au–Ag alloy to electron beam irradiation. Inspired by this discovery, we used semi-empirical effective medium theory simulations to investigate monolayer formation in 30 different binary metal alloys composed of late d-series metals such as Ni, Cu, Pd, Ag, Pt, and Au. In qualitative agreement with the experiment, we find that the beam energy required to dealloy Ag atoms from the Au–Ag alloy is smaller than the energy required to break the dealloyed Au monolayer. Our simulations suggest that a similar method could also be used to form Au monolayers from the Au–Cu alloy and Pt monolayers from Pt–…

Temperature dependence of luminescence of LiF crystals doped with different metal oxides

2020

Photoluminescence and cathodoluminescence of LiF crystals doped with different binary metal oxides were measured in the wide temperature range of 50-300 K and time interval of 10−8−10−1 s after the nanosecond electron excitation pulse. Both as-grown those and crystals irradiated by an electron beam in range of absorbed dose up to 103 Gy were studied. It is shown that spectral-kinetic characteristics of the luminescence depend on the absorbed dose (type of created/accumulated color centers), the irradiation temperature, the concentration of hydroxyl, which promotes incorporation of the MeO complex (Me: W, Ti, Fe, Li) into the crystal lattice, and the cation-dopants.

Study of the Secondary Electron Yield in Dielectrics Using Equivalent Circuital Models

2018

[EN] Secondary electron emission has an important role on the triggering of the multipactor effect; therefore, its study and characterization are essential in radio-frequency waveguide applications. In this paper, we propose a theoretical model, based on equivalent circuit models, to properly understand charging and discharging processes that occur in dielectric samples under electron irradiation for secondary electron emission characterization. Experimental results obtained for Pt, Si, GaS, and Teflon samples are presented to verify the accuracy of the proposed model. Good agreement between theory and experiments has been found.

Ion source research and development at University of Jyväskylä: Studies of different plasma processes and towards the higher beam intensities

2015

MonPS16; International audience; The long-term operation of high charge state electron cyclotron resonance ion sources fed withhigh microwave power has caused damage to the plasma chamber wall in several laboratories.Porosity, or a small hole, can be progressively created in the wall on a year time scale, which cancause a water leak from the cooling system into the plasma chamber vacuum. A burnout of theVENUS chamber is investigated. Information on the hole formation and on the necessary localhot electron power density is presented. Next, the hot electron flux to the wall is studied bymeans of simulations. First, the results of a simple model assuming that electrons are fullymagnetized and …

Solving a large cutting problem in the glass manufacturing industry

2020

Abstract The glass cutting problem proposed by Saint Gobain for the 2018 ROADEF challenge includes some specific constraints that prevent the direct application of procedures developed for the standard cutting problem. On the one hand, the sheets to be cut have defects that make them unique and they must be used in a given order. On the other hand, pieces are grouped in stacks and the pieces in each stack must be cut in order. There are also some additional characteristics due to the technology being used, especially the requirement for a three-stage guillotine cutting process. Taking into account the sequencing constraints on sheets and pieces, we have developed a beam search algorithm, us…

The role of Fe and Cu dopants in electron–hole trapping and relaxation process in congruent LiNbO3

2003

Abstract The transient optical absorption and kinetics of absorption decay is studied in undoped, Fe doped, and Cu doped LiNbO 3 crystals irradiated by pulsed electron beam. The 1.6 eV band of electron polaron trapped at antisite niobium was observed in all crystal samples. The nature of centers responsible for transient absorption is discussed. Electron polarons are shown to be less stable in LiNbO 3 :Fe compared with LiNbO 3 :Cu and undoped LiNbO 3 . It is suggested that a major part of electrons and holes created by irradiation are trapped in the vicinity of dopants.

Present status and first results of the final focus beam line at the KEK Accelerator Test Facility

2011

ATF2 is a final-focus test beam line which aims to focus the low emittance beam from the ATF damping ring to a vertical size of about 37 nm and to demonstrate nanometer level beam stability. Several advanced beam diagnostics and feedback tools are used. In December 2008, construction and installation were completed and beam commissioning started, supported by an international team of Asian, European, and U.S. scientists. The present status and first results are described.

X-ray measurements of charge transfer reactions involving cold, very highly charged ions

1999

The magnetic trapping mode of the Livermore high-energy Electron Beam Ion Trap is exploited to study charge transfer reactions between cold (few eV/amu) highly charged ions and gases. By selectively puffing neutral gases and monitoring the x-ray emission, state-selective measurements of the charge transfer reaction channels are possible. The observed K-shell x-ray spectra show prominent emission from high-n levels decaying to the n = 1 ground level, which is enabled by electron capture into states with low orbital angular momentum. A comparison with modeling calculations, therefore, allows a determination of the range of principal and angular momentum quantum numbers involved in the reactio…

Watching adsorption and electron beam induced decomposition on the model system Mo(CO)(6)/Cu(111) by X-ray absorption and photoemission spectroscopies

2013

Abstract An in-depth study of the first steps of electron beam assisted growth of Mo from molybdenum hexacarbonyl on Cu(1 1 1) has been carried out exploiting the complementarity of X-ray photoemission and X-ray absorption spectroscopies. Frank van der Merwe (2D) growth mode has been observed for the completion of the two first monolayers of adsorbed molecules through a simple physisorption process. Irradiation of the Mo(CO)6 deposit by 1 keV electron beam induces a modification of molybdenum coordination, the average number of C-neighbors decreasing from 6 to 3. Decomposed molecules remain on the surface after annealing at 520 K and organize themselves, the molybdenum atoms moving in Cu(1 …

Efficient transfer of positrons from a buffer-gas-cooled accumulator into an orthogonally oriented superconducting solenoid for antihydrogen studies

2012

Positrons accumulated in a room-temperature buffer-gas-cooled positron accumulator are efficiently transferred into a superconducting solenoid which houses the ATRAP cryogenic Penning trap used in antihydrogen research. The positrons are guided along a 9 m long magnetic guide that connects the central field lines of the 0.15 T field in the positron accumulator to the central magnetic field lines of the superconducting solenoid. Seventy independently controllable electromagnets are required to overcome the fringing field of the large-bore superconducting solenoid. The guide includes both a 15° upward bend and a 105° downward bend to account for the orthogonal orientation of the positron accu…